The angular displacement sensor obtains the information brought by the outside world through the rotation and displacement of the Angle, which is sensed and transmitted by the sensor. However, many people do not know how to maintain angular displacement sensors, so there are many problems when installing and using angular displacement sensors. Then, the next vertical technology small series to specifically introduce the installation method of angular displacement sensor.

1. Install the protruding table with the sensor and fix it on the metal plate with screws, nuts or pressure plates. When installing the sensor, it is strictly prohibited to process the shaft housing with cars, drilling tools, etc., to avoid the impact force and pressure of the shaft or shell under the external impact force and pressure, and the axial and radial of the shaft should not be affected by the impact force and pressure (static pressure should be less than 300 N). Do not loosen the screws on the sensor and rotate the fastening ring.

2. When the sensor shaft is connected with other components, attention should be paid to keeping the axis straight (including the working state). If the axis is deviated, it is recommended to use a universal joint or bellows to avoid bending deformation of the sensor shaft and damage to other devices, thus affecting the use of.

3, water droplets, vapors, solvents and corrosive gases should be prevented from invading the sensor, and metal chips or other powders should be prevented from entering the sensor.

4, the external wiring of the sensor should be welded in the front waist slot, and should not be welded as far as possible on the top of the front. No more than 45W of ferrochrome should be used for welding, and the welding time should be less than 5 seconds. The wire should not be pulled during welding and uncooled transmission, so as not to pull out the brush wire or the entire wire, or even fall off. When welding, the use of flux and oil should be minimized to avoid flux steam entering the sensor through the front end, so that the steam cooling and deposition on the surface of the resistance element, resulting in the equivalent noise deterioration, or even open circuit.

Shenzhen Liyi Technology Co., Ltd. is a professional production and sales of displacement sensor, laser displacement sensor, Angle displacement sensor, spectral confocal sensor company, in need of friends can call to consult Liyi fiber coaxial displacement sensor manufacturers. Welcome your call!